Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

In case anyone has ignition problems with an Eachine type engine...

I've had one of the M90 engines for a while and it has run really well.  I took the engine off the box to check a few things and didn't notice the earth wire had become detached when I tried to start it.  Result: fried Hall sensor.

Except that the sensor is not a Hall, but a glass reed switch and was still good.  The fried component is in the module box.
Is there a way to get into the box of tricks to be able to get at the components?  If not, another $55 for a new ignition module.

Dave
The Emerald Isle