Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

Captured a really big compound Marklin 4158/11 steam plant
Page 9 of 20
Posted: 6:26 PM - Oct 21, 2013
redryder
Here is a short and not well regulated air test but is enough to prove the
engine and dynamo work just fine.
 

 
 
 
And more pictures:
 












 
 
 
 
 
 
 
 
________________________________________
Posted: 6:40 PM - Oct 21, 2013
Maxwell
WOW, Music to my ears, and Beauty in motion.  :cheers:
________________________________________
Posted: 7:23 PM - Oct 21, 2013
Earlytimes
A Super find... Gil
________________________________________
Posted: 7:39 PM - Oct 21, 2013
redryder
xlchainsaw:984557 wrote:nice engine ...fantastic burner ..i would love to
see it in flamesjust a tube with a wick in itdown to a vented tank
??...it will drink the meths :shock: so stock up
The burner has a few leaky seams so will not be fired until properly
repaired.
 
I was also hoping to light it up!
 
Gil
________________________________________
Posted: 7:59 PM - Oct 21, 2013
redryder
__________________________________________
wrote: What is the weight of that monster? and
compared to your largest Jensen how is it? larger smaller?
Good question....
 
Clearly the Jensen 51 is larger at 34" wide and 27" tall with the tower.
 
The better comparison (photos included) is to the Jensen #50 which is the
power for the 51.
 
The Marklin 4158/11 is a bit larger at 21.6" X 21.6" (base) vs. 20" X 18"
for the Jensen 50.
 
The Marklin weighs about 36 lbs.
The Jensen weighs about 30 lbs.
 
The Jensen boiler has a greater capacity as it is a full 5" X 10".
Both have feed water pumps.
 
Gil
 
 
Here are pictues of the 4158/11 and the #50 side by side
and then with a Jensen 10 and a Steamco included in the picture.
 
These should give you a good sense of what a massive beast it is.
 




 
 
 
________________________________________
Posted: 8:24 PM - Oct 21, 2013
 
However it will be a while as I need to free up a couple stuck valves,
replace some seals
such as for the boiler plug and site glass and hopefully without breaking
the glass.
 
I am considering replacing the belt with one that isn't so thick.
 
Also, the spirits leak out of the burner almost as fast as I fill it so a
little work is ahead.
 
Gil
________________________________________
Posted: 9:25 PM - Oct 21, 2013
redryder
Stoker:982422 wrote:Fantastic Gil, couldn't be happier for you ... or for
the engine, in finding such a good home!
 
Congratulations to you both!!! :wink:
Thanks, Daniel. Yes it has found a good home.
 
Gil
________________________________________
Posted: 12:47 AM - Oct 22, 2013
________________________________________
Posted: 7:33 AM - Oct 22, 2013
Freespawn
You have ruined another keyboard ........ Drool .........
________________________________________
Posted: 4:48 PM - Oct 22, 2013
Dr. Rog

 
An absolutely amazing engine. Most of the patina was just dried oil by the
look of it.  :shock:
________________________________________
All times are UTC-05:00
Page 9 of 20