Post by: Swift Fox on August 17, 2019, 03:16:33 am
[attachimg=1]
Post by: Swift Fox on August 14, 2019, 02:11:16 pm
[attachimg=1]
I'll do another thread with some better photos later, the base is going to be a bit more complex due to the reversing mechanism, the base shown in the photo is just temporary.
Post by: Swift Fox on August 09, 2019, 04:18:16 am
Post by: Jim on August 08, 2019, 08:52:41 pm
Jim sorry to be a pain but what are the dimensions of the smaller plinth?, i've got the depth from your other photo.
One thing i've realised i might have to do is to cut a recess out to accommodate the reversing mechanism on my base as i don't know what the clearance will be until i get it.
Your bases look like silky oak?
Hi Philip the smaller plinth is silky oak, the larger plinth is a tropical hardwood from up north.
The dimensions of the small plinth are -
60mm wide
15mm high (this is high enough to for the flywheel to clear the bottom plinth)
105mm long
Post by: Swift Fox on August 06, 2019, 12:04:27 pm
One thing i've realised i might have to do is to cut a recess out to accommodate the reversing mechanism on my base as i don't know what the clearance will be until i get it.
Your bases look like silky oak?
Post by: Swift Fox on August 06, 2019, 03:36:28 am
I just received notification from MSM today that my Pevensey has been shipped out!
Anyway i'm sure they might be others who would benefit from this too. ;)
Post by: Jim on August 05, 2019, 10:34:17 pm
Now why would Philip need these measurements?? ;)
I have noooooo idea :)
Post by: Nick on August 05, 2019, 10:23:10 pm
Post by: Jim on August 05, 2019, 10:19:15 pm
[attachimg=2]
[attachimg=3]
[attachimg=4]
[attachimg=5]
Post by: Jim on August 05, 2019, 10:17:34 pm
Any questions, just sing out. You can see how there is a smaller plinth that the engine(s) are on and then that's mounted to the larger plinth.
[attachimg=1]
[attachimg=2]
[attachimg=3]
[attachimg=4]
[attachimg=5]
[attachimg=6]