Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc => Topic started by: america12mj on September 28, 2019, 04:09:52 am
-
494/5000
Good morning all.
I started to look at my M91 and a major problem is to watch.
the bearing that allows the decompression rod to go up and down, is simply mounted in force on its axis, and the axis is stuck only by cyano!
after two starts, the axe take off and the bearing went across.
no breakage, but great fright.
I dismounted everything and fixed the axis to the ultra strong loctite.
I think Jin should think of more mechanical assemblies.
??? ???