Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Model & Toy Steam Engines – Stirling Cycle – Flame Lickers – Small Antique Originals => Topic started by: njrich50 on October 31, 2019, 08:26:24 am

Title: Re: Need fitting help
Post by: classixs on October 31, 2019, 10:18:48 am

I believe that Bruce "St Paul Steam", might be able to help you out  :)

He has made some very nice in/outlet valves for Jensen engines from time to time.

You can see one of the types on the boilers, in this "SPS setup" i made a few years ago:
[attachimg=1]

Title: Need fitting help
Post by: njrich50 on October 31, 2019, 08:26:24 am

I need to find a fitting for my Jensen boiler to run on compressed air. Does anyone know where to buy one and what size should I get for compressed air inlet.


Thanks, Rich