Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
Builds, Repairs, Show Your Machines! => Videos The Office of Steam Cinema => Topic started by: txlabman on May 07, 2020, 05:58:23 pm
-
It would be great if Gil could give some history on the brewery and the builder.
I would love to know what all Russell Snyder has built, I only have a small Buckman of his. I tried for a couple of his mobiles in an auction a few months back, but fell short. His work is so good it looks original 8)
-
Thanks for all of the nice feedback guys!
I think the saw would cut better hooked directly to the engine.
An experiment for later.
I plan on steaming the brewery when I am back in Plano. To my knowledge, and Gil can correct me, I don’t think it has ever been steamed.
It would be great if Gil could give some history on the brewery and the builder.
Stay Safe and Sane,
Charlie
-
Great video, Charlie! I had near as much fun watching it as you had making it!
Gil
-
That sure is a nice setup, thanks for sharing Charlie! :)
-
You should be making barrels to put all that beer you are brewing in. ;D
-
So much action 8) Still have all your fingers? ;)
I do. And that wasn’t balsa wood I was cutting! 🤠
Have you tried ripping a board instead of cross-cutting? Going to have to make a really small push stick :D Maybe you could make some flooring for another workshop :D
-
So much action 8) Still have all your fingers? ;)
I do. And that wasn’t balsa wood I was cutting! 🤠
-
Your table saw cuts better than my 10" Craftsman.
-
So much action 8) Still have all your fingers? ;)
-
Thank you Daniel.
It was a lot of fun making the video.
Great COVID therapy. 🤠
-
A whole lot going on there Charlie .... a whole lot of fun that is!!!
Very Nice!
-
https://youtu.be/FD60LnlQAEU