Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc => Topic started by: JinMachine on November 21, 2020, 06:12:33 pm

Title: Re: Mini Impeller Pump P70 VIDEO
Post by: Raphael on November 22, 2020, 03:09:42 am

Bonjour Jin,
You never stop impressing me by your skillness and your imagination  :)

Title: Re: Mini Impeller Pump P70 VIDEO
Post by: St Paul Steam on November 22, 2020, 02:51:57 am

I do wonder what the minimum power needs are to run this ? I imagine the dual grooved drive pulley is there for a reason....probably take a 3/4" bore & above engine to drive (with dual grooved pulley as well)

Title: Re: Mini Impeller Pump P70 VIDEO
Post by: Nick on November 21, 2020, 11:04:17 pm

These will sell well  8)

Title: Re: Mini Impeller Pump P70 VIDEO
Post by: Jim on November 21, 2020, 09:48:37 pm

@dlyyld thanks Jin, it certainly is moving a lot of water.

Title: Re: Mini Impeller Pump P70 VIDEO
Post by: St Paul Steam on November 21, 2020, 09:00:42 pm

Thanks for the video Jin  , it seems to perform very well.

Title: Re: Mini Impeller Pump P70 VIDEO
Post by: Adirondack Jack on November 21, 2020, 06:23:40 pm

Very nice. Pump seems very efficient.

Title: Mini Impeller Pump P70 VIDEO
Post by: JinMachine on November 21, 2020, 06:12:33 pm

https://youtu.be/_m1xV2b2aIs