Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc => Topic started by: odu50 on January 22, 2021, 12:28:05 pm

Title: Re: Engine Converting
Post by: odu50 on January 25, 2021, 03:57:52 pm

Hi  :D

Thank you very much for your comments, it is a pleasure to read you
Christian.

Title: Re: Engine Transformation
Post by: Jim on January 24, 2021, 07:09:01 pm

Wonderful model engineering work there.

Title: Re: Engine Transformation
Post by: RedRyder on January 24, 2021, 05:53:00 pm

Well done, Christian...!

Very well done...!!!

Giol

Title: Re: Engine Transformation
Post by: Adirondack Jack on January 24, 2021, 02:32:27 pm

Quote from: cheepo45 on January 23, 2021, 01:52:01 pm

The belt operated hit and miss governor with different size pulleys for different speeds is genius!
Very nice engine!
 Scott

Exactly my thoughts as well.

Title: Re: Engine Transformation
Post by: cheepo45 on January 23, 2021, 01:52:01 pm

 The belt operated hit and miss governor with different size pulleys for different speeds is genius!
Very nice engine!
 Scott

Title: Re: Engine Transformation
Post by: Nick on January 22, 2021, 08:53:11 pm

Great Work! I love it  8)

Title: Re: Engine Transformation
Post by: Raphael on January 22, 2021, 04:29:30 pm

Bonjour Christian,
I agree with our colleagues, great jon indee ! I knew you were a steam specialist, I discover another face of your skillness.

Title: Re: Engine Transformation
Post by: Woe is me on January 22, 2021, 03:58:37 pm

I like it too. Good work.

Title: Re: Engine Transformation
Post by: St Paul Steam on January 22, 2021, 02:17:01 pm

Nice work Christian,  I like the deep Ker-thunk sound it makes ,just like the big boys.

Title: Engine Converting
Post by: odu50 on January 22, 2021, 12:28:05 pm

Hi.
Here, information about my work over the past few months.
A motor system Hot Bulb engine from Germany transformed into Hit & Miss.
I used a mixer provided by Pm Research, a regulator of my stock and an electronic ignition with Hall sensor.
I built the muffler and installed the spark plug.
It works with synthetic gasoline "Aspen" (gasoline for mower, brush cutter, chainsaw.)

Regards Christian.

https://youtu.be/FZkiOErPPFE