Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => Wanted => Topic started by: St Paul Steam on January 25, 2021, 09:15:08 am
-
Thanks Nick ,that'll help a bunch. Can you give me the measurements as well (I know it's on a curve) & that will shorten the width a little bit.
I wrapped a piece of paper around the boiler and marked it because of the curve and I got 3/4” tall x 1-1/2” wide
Thanks again Nick 😊👍
-
Thanks Nick ,that'll help a bunch. Can you give me the measurements as well (I know it's on a curve) & that will shorten the width a little bit.
I wrapped a piece of paper around the boiler and marked it because of the curve and I got 3/4” tall x 1-1/2” wide
-
Thanks Nick ,that'll help a bunch. Can you give me the measurements as well (I know it's on a curve) & that will shorten the width a little bit.
-
Best one I got, will send it to your email at full resolution
[attachimg=1]
-
My 45 isn’t the nicest, but if the tag is good I will get you a picture. Only problem I can think of is that they’re on a curved boiler, so may not be perfect...
-
Hello folks
to help finish off the Jensen #45 project , I need your help. What I need is a high resolution picture of the #45 candlestick boiler tag , I don't currently have one inhouse.(I can get one reproduced) if you have a spare original tag ,that would be even better.
Thanks in advance 😊