Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Model & Toy Steam Engines – Stirling Cycle – Flame Lickers – Small Antique Originals => Topic started by: PO9R4S4CHE on June 24, 2021, 08:39:36 am

Title: Re: Bing 1637
Post by: Earlytimes on July 13, 2021, 11:42:03 pm

  They show up once in awhile.

Title: Re: Bing 1637
Post by: PO9R4S4CHE on July 13, 2021, 11:29:49 pm

Thats a life goal, the largest bing vertical engine.  I have the 1637 )or 112(? and then also the 130/114   Id love the 116 if i come across it!  51cm high or so!  Life goals for sure!  If you ever sell yours  keep me in mind. 

Title: Re: Bing 1637
Post by: Earlytimes on July 13, 2021, 11:08:15 pm

Quote from: PO9R4S4CHE on July 13, 2021, 10:54:53 pm

Thanks so much.  yes i repaired sight glass i posted about it in restorations.  the burner and chimney were from the kindest seller glueckskind101 you will need to use a browser to see her stuff. Really awesome seller.

  Yes, I know the seller. I'll check out your sight glass repair.  It's a nice engine you have there. I have the largest one from that series, I think they made 4 sizes. 

Title: Re: Bing 1637
Post by: PO9R4S4CHE on July 13, 2021, 10:54:53 pm

Thanks so much.  yes i repaired sight glass i posted about it in restorations.  the burner and chimney were from the kindest seller glueckskind101 you will need to use a browser to see her stuff. Really awesome seller. 

Title: Re: Bing 1637
Post by: Earlytimes on July 13, 2021, 09:36:34 am

Hello Jason,
 
Nice Bing vertical.  You were lucky to find a nice matching burner and stack.

 Did you repair the sight glass ?

Title: Re: Bing 1637
Post by: PO9R4S4CHE on June 24, 2021, 08:41:30 am

ALSO. any and all info on this engine is Loved!  its stamped 1637 GB with newer bing mark.  im thinking its a 130.112.2 with feed pump or vulcan?  its 31.5cm tall

thanks

Title: Bing 1637
Post by: PO9R4S4CHE on June 24, 2021, 08:39:36 am

Finally all complete.  purchased the engine minus burner and stack.  now i need to clean up and restore to perfect full function.  im gonna need help and pointers on the water sight please!  its a U shaped one and i have to re install and seal. i want this to turn out perfect.  id love all feedback.

thanks all!

Jason