Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc => Topic started by: Adirondack Jack on February 08, 2022, 09:14:41 pm
-
Looking forward to seeing the fruits of your labor Jack.
-
Looking forward to seeing your progress, Jack 👍
-
Back in November, I tore down the engine after the oil snafu. I had company coming, so bagged and stowed the project until a week or two ago. My Glaucoma-ravaged vision is best in the morning, so I’ve been slowing putting the engine back together. When I went to mount the gas tank, the fuel line was twisted, and when I tried to pop the line off the nipple with my fingernail, a cold solder joint let go, and the nipple came with the line.
I bagged and stowed again, and ordered silver bearing tin solder and flux, and tonight, eyes not worth a damn, THC and CBD kicking in, I fired the mini pencil torch and put a new outlet on the tank. Pro tip. Use a long piece of tubing when soldering in a nipple, and cut it off with a Dremel cut off wheel afterward. It’s a lot easier to handle the long piece of brass than a pre cut short nipple.
Done and mounted back on the engine. Next warm day we get, I’ll oil and fuel and give it a whirl.