Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Model & Toy Steam Engines – Stirling Cycle – Flame Lickers – Small Antique Originals => Topic started by: D E Jones on March 22, 2023, 09:51:13 am
-
I really like that one, well done!
I a while back, purchased this flatbelt jackshaft from Andrew "Scalex"...
It was made by late Geoff "OzSteamDemon" Swale, with a coupling and height fitting directly onto the outer end of a Jensen #20 crankshaft.
(Attachment Link)
(Attachment Link)
Jan , is that a clutch mechanism on the crank shaft side ?
-
He sure did, he's missed by so many people. Hey you're not too shabby your self.
-
The old SteamDemon sure did make some nice things. I wish I had that talent .
D. E. Jones
-
I really like that one, well done!
I a while back, purchased this flatbelt jackshaft from Andrew "Scalex"...
It was made by late Geoff "OzSteamDemon" Swale, with a coupling and height fitting directly onto the outer end of a Jensen #20 crankshaft.
[attachimg=1]
[attachimg=2]
-
Very neatly done, nice presentation.
-
Since PM Research #7 engines have no provisions for pulleys, I devised this countershaft to flat belt to the Flywheel. I can now drive other things with it , such as my machine shop . You may have noticed in some of my other posts , I can replace it with a generator .
D. E. Jones