Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc => Topic started by: crazydoug on July 12, 2024, 09:48:46 am
-
I have your new ignition module. Jin put it in a package for mr with other parts. I will send it along.
Still.... it would be nice to know more about the 2 wire sensor.
-
G'day Doug.....hopefully one of the forum leccy experts can help you out mate.
-
I wonder if anyone has had to troubleshoot jins 1.5v ignition system as used on my oddball engine. Everyone i talk to assumes it uses a hall sensor, but i have never seen a hall sensor that only has 2 wires. I think this ignition system must be using a 2 wire reed switch being closed by the permanent magnet located in the brass timing gear. These 2 systems require different troubleshooting methods. I doubt you could damage a reed switch but could easily damage a hall sensor by improper testing methods.
My module is producing no spark after only about 10 min total run time. This is unusual as i have had many of his engines with no ignition problems.
I would like to know what part i need before contacting jin to purchase replacement parts. It may be also that the ign system is only available as a complete unit- a shame if it is only the sensor/reed switch.
Crazydoug