Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Model & Toy Steam Engines – Stirling Cycle – Flame Lickers – Small Antique Originals => Topic started by: Steamburns on August 01, 2024, 02:47:11 am
-
Hey my steamers. Worked on this periodically throughout the day. My goodness are these old engines finicky. Did much exhaust repair through failed & repeated soldering until just right. Now it has no leaks within the exhaust.
I also completely disassembled the engine components entirely to find out why there were tight spots in the flywheel, come to find out a baring spacer that keeps the flywheel stable was binding up against the stanchions.
The thing runs smoother than butter. I can spin the flywheel with my hand and it will revolved for
About 5 seconds before stopping. Until max pressure it now actually has power enough to run the water pump.
I am greatly pleased and this puppy will surely be one of my pride & joy engines.
Here is a photo of WIP along with the engine in full function.
[attachimg=1]
https://www.youtube.com/watch?v=6EcotaT1XhE