Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc => Topic started by: RedRyder on May 03, 2025, 07:27:51 pm
-
A very nice engine Gil.😊
Thanks, Bruce!
-
A very nice engine Gil.😊
-
What a nice engine Gil.
Thanks, Jim!
-
I took one of the clips that I filmed vertical and uploaded it as my first experience publishing a "Short".
They seem to get a lot of views.
Good Job. Showed up in my feed and asked for feedback. Great engine. Cant wait to see it under a load. Shorts are the best. I try and link them to my kong form videos to drive duek traffic. Great Job Red
Jason (Attachment Link)
Thanks, Jason!
-
What a nice engine Gil.
-
I took one of the clips that I filmed vertical and uploaded it as my first experience publishing a "Short".
They seem to get a lot of views.
Good Job. Showed up in my feed and asked for feedback. Great engine. Cant wait to see it under a load. Shorts are the best. I try and link them to my kong form videos to drive duek traffic. Great Job Red
Jason[attachimg=1]
-
I took one of the clips that I filmed vertical and uploaded it as my first experience publishing a "Short".
They seem to get a lot of views.
-
Pretty amazing fine tuning there Gil!
Kept expecting it to hang up a TDC, so the suspense was killing me ... ;c)
That is precisely the same suspense that I felt every time it was ready to fire.
-
Thank you, Daniel..!!
Thank you, Hans..!!
-
That's a true joy to watch ! Well done sir !
-
Pretty amazing fine tuning there Gil!
Kept expecting it to hang up a TDC, so the suspense was killing me ... ;c)
-
Had a little time last week to move the Gearless Olds model outdoors
And give it a good run. I adjusted the pendulum governor to slow it down about as far as mechanically possible.
Enjoy!
Gil
https://www.youtube.com/watch?v=npeJBBkMmB0