Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc => Topic started by: RedRyder on June 30, 2025, 08:18:23 pm
-
Scott, you might just get a chance to see it.
I will try to get it to R&T in August.
-
Very nice! Hope to see it in person someday.
Scott
-
Beautiful engine and runner Gil 8)
-
Beautiful addition to the collection Gil.
Thanks, Jim!
-
That is really just spectacular to view, and runs a treat too!
My only question is ... how does it run pulling a load?
Thank you. It should run great pulling a load. You just speed it up and when a load is applied the pendulum governor will make it fire more often.
-
I am unable to open the link.
Try again. It works fine.
If that fails search up my YouTube channel @reddrryder or by searching for reddrryder video. Then follow a link to my channel.
-
I am unable to open the link.
-
Beautiful addition to the collection Gil.
-
That is really just spectacular to view, and runs a treat too!
My only question is ... how does it run pulling a load?
-
A couple pictures
[attachimg=1]
[attachimg=2]
-
I agreed to acquire this fine engine a few months ago and it was delivered to me at the Coolspring Show last week.
It had never been run so it was a bit of a project getting it set up and adjusted.
I have a little more to do to get it dialed in just right.
Here it is after a lot of fiddling, adjusting, massaging parts, etc.
Enjoy,
Gil
https://www.youtube.com/watch?v=mihwjrlqg1M (https://www.youtube.com/watch?v=mihwjrlqg1M)