Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Model & Toy Steam Engines – Stirling Cycle – Flame Lickers – Small Antique Originals => Topic started by: RedRyder on January 03, 2026, 08:43:53 am

Title: Re: Steam Plant, Stuart Beam Engine, Stuart 10H, PMR Dynamo, Stuart Steam Feed Water Pump, Custom Boiler
Post by: komet163b on January 04, 2026, 12:11:59 pm

Verrrry fair deal for a very nice looking complete and working steamplant.

Good Luck,
Wayne

Title: Re: Steam Plant, Stuart Beam Engine, Stuart 10H, PMR Dynamo, Stuart Steam Feed Water Pump, Custom Boiler
Post by: RedRyder on January 03, 2026, 06:31:01 pm

Thanks, Paul!

Title: Re: Steam Plant, Stuart Beam Engine, Stuart 10H, PMR Dynamo, Stuart Steam Feed Water Pump, Custom Boiler
Post by: pwalchak on January 03, 2026, 05:55:02 pm

Gorgeous!

Title: Re: Steam Plant, Stuart Beam Engine, Stuart 10H, PMR Dynamo, Stuart Steam Feed Water Pump, Custom Boiler
Post by: RedRyder on January 03, 2026, 09:05:52 am

[attachimg=1]

Title: Steam Plant, Stuart Beam Engine, Stuart 10H, PMR Dynamo, Stuart Steam Feed Water Pump, Custom Boiler
Post by: RedRyder on January 03, 2026, 08:43:53 am

Here is my Stuart steam plant cleaned up.
I am going to sell it before or at Cabin Fever.
 
It needs a little more work to adjust the well built Stuart Steam Feed Water Pump and repair 4 lamp posts. The next custodian can take care of this. 
 
Included are:
 
·        Stuart Beam Steam Engine with faux brass water pump, brass safety rails

• Stuart 10H Steam Engine
• Stuart Steam Feed Water Pump
• Exhaust stack for 10H
• PM Research Dynamo - direct drive by 10H
• Lamp Control Board w 3 brass knife switches
• Copper Water Supply Tank
• Brass Valve and Hose with quick connect to run on air
• Safety Relief Valve
• PM Research Brass Whistle
• Custom Boiler Like a Stuart 504 with 5 water tubes
• Bix Gas Burner (gas tank not included)
• 2 Hand Wheel Valves on top of boiler (custom made)
• Stuart Site Glass with Drain Valve piped to discharge underneath
• Stuart Pressure Gauge 
• 5 Five Bolt Brass Flanges   
• Exhaust Drain Pipes neatly installed under base
• Base is 24"x 24" with brass rails on boiler front end
• 3 Displacement Lubricators

Price is 2200.


Video:

https://www.youtube.com/watch?v=IYlEIfki9aE



[attachimg=1]



[attachimg=2]



[attachimg=3]



[attachimg=4]



[attachimg=5]



[attachimg=6]



[attachimg=7]



[attachimg=8]