Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

Builds, Repairs, Show Your Machines! => Boats, Pond Yachts => Topic started by: 34046 on August 13, 2019, 09:48:46 am

Title: Bowman steam boats
Post by: 34046 on August 13, 2019, 09:48:46 am
Interested to know the type of wood these boats were made from and if the curved sides would have been steamed to shape please ?

Thanks

Stuart
Title: Re: Bowman steam boats
Post by: Tony Bird on October 01, 2019, 03:04:30 am
Hi Stuart,

I think they were made of pine about 5/16" thick.  I don't know if the early models were steamed to bend the sides sides but the later models Eagle. Snipe and Swallow were cut curved from a block of wood. The Eagle was the largest and cut first from a block of wood and the curved surface left on the block became the outside of the Snipe which after being cut became the outside of the Swallow.  So, three hulls descending in size were cut from single block of wood.  The hull bottom was about 1/8" plywood.  I have made three copies of an Eagle and a couple of a Swallow but I steam bent the sides.

https://youtu.be/ZkjxqZwaDV8

I hope this is useful.

Regards Tony.