Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Model & Toy Steam Engines – Stirling Cycle – Flame Lickers – Small Antique Originals => Topic started by: Randy Tucker on September 04, 2019, 04:06:49 pm
-
Has anyone rewound the armature of a Jensen generator? I have one that the windings are mest up on and needs to be rewound. What I need to know is how many windings go on each side of armature and approximately how much wire does it take? Thanks
-
Randy, I have seen Dorita at Jensen actually winding generators in a video. I bet she would be happy to tell you the exact wire they use and how many turns for each side.
Rog
-
Randy, I have seen Dorita at Jensen actually winding generators in a video. I bet she would be happy to tell you the exact wire they use and how many turns for each side.
Rog
I was thinking the same thing....& then read this, Yes, Dorita should be able to tell you.
-
I was thinking there was a video of her winding armature and she told the number of windings. Can't seem to be able to find it now.