Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
Office of Steam ~GLOBAL POWER-UP~ virtual engine show => Ye Olde Corner Tavern Grand Re-Opening for the 2024 GPU => Topic started by: Damnfmaschine on February 26, 2021, 10:17:42 pm
-
Hope it fits here guys?
https://youtu.be/HBZaJK2s6V8
-
😂 My steam-up bench is right next to a chest freezer. Not good one small pieces roll under there! :D
-
I know that feeling all to well.
Finish making a 1.7 mm bolt move to bench and drop it .
I have learnt it is quicker to make another than waste time looking
Cheers
Dennis
-
hahaha!
I have thick industrial rubber floor matting in my shed, its great for standing on for long periods....not so great when you drop something and it turns everything into a 'superball'.
-
Who the heck is looking in my windows. I am glad you didn't catch me down on all fours like a drunk sailor.
-
😂 😂
-
What!!!!!!! us sailors get drunk? never. We are clean living God fearing gentlemen
-
Tom ,Jim , Dennis , Nick I have had all those issues at some point ,I also have just resigned myself to making a new part after a few seconds looking for that damned dropped part , have you ever purposefully dropped a second part thinking it might lead you to the 1st part....only to loose it also 😉
-
I found a nut from my Eitcech Ferris wheel nearly 6 months after the build in our living room carpet... We had bought a new (powerful) vacuum and it found it in the first pass 😂
-
And speaking of vacuums, if I lose a steel screw or nut I go straight for the Shop-Vac and grab a magnet. Much faster :D
-
I was polishing a piece of brass on the 8" buffing wheel the other day when it was ripped out of hands and took off like a projectile.
Searched everywhere I didn't find it, but I found different one that the same thing happened to a long time ago!