Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Model & Toy Steam Engines – Stirling Cycle – Flame Lickers – Small Antique Originals => Topic started by: tenniV11 on April 08, 2021, 03:44:03 pm
-
Got this nice Bing Hot Air today - and already made a first run.
The Burner for Dry fuel is not original. I just made a new one
with 2 flames (alcohol) - will add a photo tomorrow.
The sound is a purring cat - ha ha ;D
Enjoy a few seconds, Arnold
https://youtu.be/ntOlosufHPk
-
Thats the new Burner "homemade"
Made of 0.5 mm sheet metal and soldered together
In the middle is the filler cap with a very
small vent hole of 0.5 mm. It's not 100% original
but easier to handle and very effective.
Arnold
[attachimg=1]
-
Fun little engine, and a good job you did on that burner, it looks amazing!
-
Like Jan say's, you nailed it.
-
A very nice hot air engine. Runs great. The burner turned out very well.👍
-
Congratulations Arnold.
I hope you leave it as is, run it and enjoy it.
Fantastic work on the burner.
Regards,
Charlie
-
Congratulations Arnold.
I hope you leave it as is, run it and enjoy it.
Fantastic work on the burner.
Regards,
Charlie
Hi Charlie
In earlier days I have polished the engines to new and also repainted -
but today I prefer patina and signs of wear - what is important, however, is that they work perfectly
Greetings to Texas, Arnold
-
Congratulations Arnold.
I hope you leave it as is, run it and enjoy it.
Fantastic work on the burner.
Regards,
Charlie
Hi Charlie
In earlier days I have polished the engines to new and also repainted -
but today I prefer patina and signs of wear - what is important, however, is that they work perfectly
Greetings to Texas, Arnold
I have been on the same journey in my collection Arnold. :)