Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc. => General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc => Topic started by: Alan on May 21, 2019, 03:42:20 am
-
Videos from a model engineer friend in Geneva
https://youtu.be/4Zz0M4yheH4
https://youtu.be/N3EtRkJUX3o
Model engines with butane
https://youtu.be/-Z4MrnKT1KI
https://youtu.be/xb2yB6ZfHog
-
Very nice 8) Love the little Red Wing, the originals were built only a few miles from me
-
PM Research offers Red Wing scale model kits of Hit & Miss engines, including unmachined castings and bar stock with plans. Unfortunately they cost about twice as much as Jin's Microcosm M90 complete and look to take a whole lot of difficult machining to finish.
-
PM Research offers Red Wing scale model kits of Hit & Miss engines, including unmachined castings and bar stock with plans. Unfortunately they cost about twice as much as Jin's Microcosm M90 complete and look to take a whole lot of difficult machining to finish.
Yes I have seen plenty of them, just haven't found myself ready to start another collecting addiction :D
-
Yes I have seen plenty of them, just haven't found myself ready to start another collecting addiction :D
Actually Nick .... the point I was trying to make was, what an absolute bargain Jin's little Hit & Miss engine really is!
-
Actually Nick .... the point I was trying to make was, what an absolute bargain Jin's little Hit & Miss engine really is!
Well... it's a bargain for now... until it causes an addiction with scale hit & miss engines and I end up with more :D
-
Thanks for sharing the videos Alan.
-
Well... it's a bargain for now... until it causes an addiction with scale hit & miss engines and I end up with more :D
And you WILL end up with more! My wife reminds me of the time i said i just wanted ONE model hit/miss engine to take to shows- I currently have 18, half of which i have built with no prior machining skills. You assuredly have the addiction Nick!
crazydoug
-
And you WILL end up with more! My wife reminds me of the time i said i just wanted ONE model hit/miss engine to take to shows- I currently have 18, half of which i have built with no prior machining skills. You assuredly have the addiction Nick!
crazydoug
Well, I have two in the family with trailers full of scale hit & miss engines so I guess I'm really in trouble... :D