Office of Steam Logo_1

« previous next »
Pages: [1]

Author Topic: Model Hit and Miss Engine - 2inch bore Briggs-stratton crank and gears  (Read 914 times)

  • Jr. Member
  • **
  • Posts: 251
Model Hit and Miss Engine - 2inch bore Briggs-stratton crank and gears
« on: October 06, 2019, 01:40:41 pm »



Cast Iron Rings, Steel Sleeve. Asking $725.


Len.
Logged

  • Jr. Member
  • **
  • Posts: 251
Re: Model Hit and Miss Engine - 2inch bore Briggs-stratton crank and gears
« Reply #1 on: October 06, 2019, 01:44:57 pm »
Note this engine is time to roll counter clockwise.
Logged

  • Sr. Member
  • ****
  • Posts: 1016
  • Location: Ontario, Canada
Re: Model Hit and Miss Engine - 2inch bore Briggs-stratton crank and gears
« Reply #2 on: October 07, 2019, 05:02:53 pm »
Does it run?
Logged
Bob

  • Jr. Member
  • **
  • Posts: 251
Re: Model Hit and Miss Engine - 2inch bore Briggs-stratton crank and gears
« Reply #3 on: October 07, 2019, 05:44:28 pm »
Hi,
 Will gas it up and post video of results. Based on the compression shown in vid I posted, I think so. ;D


Len
Logged

  • Jr. Member
  • **
  • Posts: 251
Re: Model Hit and Miss Engine - 2inch bore Briggs-stratton crank and gears
« Reply #4 on: October 07, 2019, 06:31:53 pm »
Found a video of last time I ran it. For some reason sound did not work.

Len.

Logged

  • Jr. Member
  • **
  • Posts: 251
Re: Model Hit and Miss Engine - 2inch bore Briggs-stratton crank and gears
« Reply #5 on: October 08, 2019, 09:57:20 am »
Comes with accessories...
Logged
Pages: [1]
« previous next »