Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

Managed to get a few hours in the workshop this week, but i am still waiting for a 10mm reamer so there is much i cannot do at present.

I did ream the main bearing holders and make the main bearing bushes which are now in place ready to line ream them.

In the mean time i have been moving on with some horrid fiddly bits, my eyesight is making this very hard going and i am not getting the quality i had hoped for, but it will work.

Govenor arm and lock out assy done.



Finished and fitted.



And my paint turned up, so i have the base painted.  i wanted to get this done so i can mount the rather flexible crankcase square on the base before reaming the main bearings to ensure everything is in good alignment.



Kind regards
Ade