Office of Steam Logo_1

« previous next »
Pages: [1] 2

Author Topic: First 2 Runs and Adjusting the Microcosm M12 Gas Engine Model  (Read 2057 times)

  • Administrator
  • Engineer
  • *****
  • Posts: 5070
  • Location: Connecticut - USA
Re: First 2 Runs and Adjusting the Microcosm M12 Gas Engine Model
« on: July 29, 2020, 06:13:17 pm »
Another tip....


I removed the rear plate covering the crank case end and bored two .080" holes straight through from the other side.
This lined them up perfectly to allow oiling the piston skirt with a long needle oiler when it is at bottom or top dead center.


Gil




[ Guests cannot view attachments ]




[ Guests cannot view attachments ]
Logged
Pages: [1] 2
« previous next »