Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

Hi Paul,... what's best non-destructive way to remove or rotate just the spraybar ?....there's always been lively discussions on spraybar # of holes & orientation direction for optimizing fuel atomization issues from way back i was flying Fox nitro airplane 35 & 36x motors.

Not sure. Frankly I wouldn't try it. The hole on my spray bar is facing towards one side instead of the interior of the mixer. However, my engine runs just fine so I won't mess with it. I wanted to know if my mixer was screwed in because it was loose and I wanted to use loctite to secure it. I ended up using rubberized ca adhesive. Incidentally, I just purchased some Tygon fuel tubing from McMaster-Carr as my fuel line doesn't seem to be holding up too well. The new fuel line is clear yellow.