Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
This topic
This board
Entire forum
News:
Welcome to the Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines - Enjoy!
Home
Search
Today's Posts
Login
Register
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc.
»
General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc
»
Use drill to start hit and miss emachine engine
»
Message #13978
« previous
next »
Print
Pages: [
1
]
2
Author
Topic: Use drill to start hit and miss emachine engine (Read 975 times)
Raphael
Full Member
Posts: 505
Steam passionate and collector
Location: Saint-Mandé (France)
Re: Use drill to start hit and miss emachine engine
«
on:
August 24, 2019, 02:08:28 pm »
Bonjour,
I successfully rolled a thickness of 2 mm of rubber at the end of the axis of the engine and then tightened it with the chuck of my hand drill. Bad luck, it was perfectly running but on the wrong way, my old drill has no reverse mode.
Logged
Raphaël, Membre du Modèle Yacht Club de Paris :
http://mycparis.fr/
Membre de l'Offshore Club de Paris: http://site-ocparis.wifeo.com/
Youtube :
https://www.youtube.com/rhavrane
Print
Pages: [
1
]
2
« previous
next »
The Regular Stuff: Chat, Buy, Sell, Off Topic, etc.
»
General Discussion - Scale Model Gas Engines - Hit & Miss - Throttle Governed - Non-Compression – etc
»
Use drill to start hit and miss emachine engine
»
Message #13978