Great job refinishing the compressor and motor. Fortunately,
mine had a good motor. It was all dirty but the compressor and
motor paint is ok. Unfortunately, the pressed base is badly
rusted and the curved edge is gone in places. Fortunately, it
is not a big deal and something will come to me as to how to
replace it. In the meantime, it has a job.
I did run mine again to double-check my solution for the
wandering KJ. Just set it on a bit of rug! If the bit is
small it won't have much damping mass so the rug might slide
a bit. In that case, apply and dry some silicone spots on
the bottom. Now, what about the noise!
Two thumbs up,
Wayne