Office of Steam Logo_1

« previous next »
Pages: [1]

Author Topic: tiny EP engine with vertical saw  (Read 10616 times)

  • Full Member
  • ***
  • Posts: 597
tiny EP engine with vertical saw
« on: September 17, 2025, 04:24:20 pm »
Plank made a series of these little engines on a common base with one of their toy machine tools. This one is from around 1900 and has a scotch yoke-driven vertical saw. Amazing how well they run after all these years.


Logged

  • Jr. Member
  • **
  • Posts: 251
Re: tiny EP engine with vertical saw
« Reply #1 on: September 18, 2025, 09:18:55 am »
Very nice steam engine and accessory!!!
Logged

  • Global Moderator
  • Engineer
  • *****
  • Posts: 5155
  • Wherever you go ......... there you are!
  • Location: Eastern Sierra
Re: tiny EP engine with vertical saw
« Reply #2 on: September 18, 2025, 10:05:24 am »
Certainly, very high levels of quality and ingenuity were established back in that time and place!
Logged
"Information is not knowledge, Knowledge is not wisdom, Wisdom is not truth, Truth is not beauty, Beauty is not love, Love is not music: Music is THE BEST...   
Wisdom is the domain of the Wis (which is extinct). Beauty is a French phonetic corruption of a short cloth neck ornament currently in resurgence..."
F. Zappa ... by way of Mary, the girl from the bus.

  • Sr. Member
  • ****
  • Posts: 1254
  • Location: Kyle, Tx
Re: tiny EP engine with vertical saw
« Reply #3 on: September 18, 2025, 02:41:12 pm »
Very nice old engine with its saw - love the balance wheel.
Logged
Richard

  • Full Member
  • ***
  • Posts: 457
    • WeedenSteam
Re: tiny EP engine with vertical saw
« Reply #4 on: September 18, 2025, 04:11:56 pm »
Love the cast iron frames on that saw, nice little engine as well.  :)
Logged
Frank C.
http://weedensteam.com
       - engine identification and parts

  • Full Member
  • ***
  • Posts: 597
Re: tiny EP engine with vertical saw
« Reply #5 on: September 18, 2025, 07:26:48 pm »
Thanks for you comments. Most of the cast parts on the smaller Plank engines and accessories are cast in a lead alloy, so have to be very careful--I've seen a few half melted flywheels.
Logged

  • Global Moderator
  • Engineer
  • *****
  • Posts: 5155
  • Wherever you go ......... there you are!
  • Location: Eastern Sierra
Re: tiny EP engine with vertical saw
« Reply #6 on: September 18, 2025, 07:52:09 pm »
I've seen some Weedens with melted flywheels too!

I guess lead was easier to work with back in the day!?!?
Logged
"Information is not knowledge, Knowledge is not wisdom, Wisdom is not truth, Truth is not beauty, Beauty is not love, Love is not music: Music is THE BEST...   
Wisdom is the domain of the Wis (which is extinct). Beauty is a French phonetic corruption of a short cloth neck ornament currently in resurgence..."
F. Zappa ... by way of Mary, the girl from the bus.
Pages: [1]
« previous next »