Office of Steam Logo_1

« previous next »
Pages: [1]

Author Topic: Coarse or fine tap and die?  (Read 8415 times)

  • Jr. Member
  • **
  • Posts: 105
  • Location: Newcastle upon Tyne UK
Re: Coarse or fine tap and die?
« on: September 02, 2024, 02:09:49 pm »
Most of my taps & dies have been purchased secondhand, sometime in job lots - always go for decent quality brands though and if you have a lathe then a tailstock die holder is a very useful addition.  Some form of tapping guide is also beneficial

Dave
Logged
In a world of small engines every man is a giant
Pages: [1]
« previous next »