Office of Steam Logo_1

« previous next »
Pages: [1]

Author Topic: Homemade crankshaft techniques...anybody have any to share?  (Read 476 times)

  • Jr. Member
  • **
  • Posts: 251
Homemade crankshaft techniques...anybody have any to share?
« on: March 31, 2019, 10:11:13 am »
Hi all,
 Tinkering to improve the governor latch led to a bent pushrod. Further inspection found crankshaft failure as well. Two steps forward 10 back! Looking for  suggestions that might be an improvement on current revision.

Len.
Logged

  • Jr. Member
  • **
  • Posts: 251
Re: Homemade crankshaft techniques...anybody have any to share?
« Reply #1 on: March 31, 2019, 10:15:58 am »
Last post was most recent pic. Here is the first pic I took. Parting 3inch stock on a 9inch southbend, the things you do when your saw is 200 miles away.
Logged
Pages: [1]
« previous next »