Office of Steam Logo_1

« previous next »
Pages: [1]

Author Topic: Help with separating brass governor intake fittings  (Read 749 times)

  • Sr. Member
  • ****
  • Posts: 1202
Help with separating brass governor intake fittings
« on: August 04, 2021, 01:51:44 pm »
  This governor body has a throttle wheel at the top.
I turned it without effect and the throttle wheel
came off in my fingers.  Already broken.  And, I think
the business end of the throttle needle-valve is still
in there.  I think this is not helping the engine to
run.

  So, I'd like to take the top throttle fitting off but it
seems almost impossible.  I tried painting the seam many
times with alcohol, then acetone, but it is still stuck.
I tried heating it with a soldering iron, but no joy.  I
can always remove the governor and run it but the governor,
which works, is one of the reasons I bought it.

Hmmm.  Any ideas that don't involve brute force? 

I added a photo and diagram


Thanks,
Wayne
Logged

  • Full Member
  • ***
  • Posts: 310
  • Addicted to Steam
  • Location: San Diego California
    • My Youtube Channel
Re: Help with separating brass governor intake fittings
« Reply #1 on: August 05, 2021, 07:34:25 am »
Ive looked at this a few times over.

I dont have correct answers just ideas.

The two flanges that are screwed together are stuck or the piece they connect to directly?

Any stripped socket or screw can be turned into a flat head screw with a dremel first.  if that fails they can be drilled out.  [last resort]

How good are you at soldering?

In the automotive world many similar issues

If I were to takle this i would clean the hell out of the piece and solder a drill bit or impact bit on and then connect it with the impact driver where u soldered on whatever attachment you used.

I think with slow and concise use [wrap engine or screw down so its stable] as long as your solder job is stronger than the "stuck" part the vibrations may pop it off

this is how you get a spark plug thats stuck out.  Solder and torque.  Sometimes they need to clean and resolder a few times before its successful.  a Penetrant oil will help [after soldering do not use around heat!]

After just take the top removed flange heat the solder off and reclaim your bit and clean up the piece.

You must use an impact driver a drill wont work.  Or if u have any other high vibrations device. Maybe a torque wrench but prolly overkill.  [or try a Beach Boys album I hear they have Good Vibrations]

Good Luck

Offering only ideas and not solutions maybe you will run with!

Jason
Logged
Love steam engines, especially older German made.  Love the more clockwork style.  Addicted to this stuff!
Pages: [1]
« previous next »