Office of Steam Logo_1

« previous next »
Pages: [1]

Author Topic: Doll Flywheel Set Screw Questions  (Read 517 times)

  • Jr. Member
  • **
  • Posts: 66
Doll Flywheel Set Screw Questions
« on: January 23, 2024, 10:28:08 pm »
The flywheel on my Doll 365/1 is drilled and tapped for 2 set screws. One screw is missing, and the other is not original and is too short to tighten down on the crankshaft. I’m fairly sure proper set screws aren’t readily available because the machine screws I have measured so far aren’t standard.

Does anyone know where I might find the correct screws?

Or

Should I re-tap the flywheel so I can use set screws that are available?

Thanks in advance for your help and suggestions
Logged

  • Global Moderator
  • Engineer
  • *****
  • Posts: 5596
  • Location: St. Paul Indiana
Re: Doll Flywheel Set Screw Questions
« Reply #1 on: January 24, 2024, 05:55:09 am »
It should still be recent enough to use standard set screws, probably metric. it wouldn't bother me though to slightly upsize & re-tap them to something you can readily get. I'd bet wilesco set screws would probably work.
Logged
Bruce, St. Paul Indiana, USA
"Originality thrives in seclusion free of outside influences beating upon us to cripple the creative mind."
  Nikola Tesla

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2529
  • Location: Jutland
    • www.SteamUp.dk
Re: Doll Flywheel Set Screw Questions
« Reply #2 on: January 25, 2024, 01:46:51 am »
Try reaching out to Jim in here, he has one of these as far as i know.
I am fairly certain that he will be happy to measure up the screws for you :)
Logged
Cheers
Jan
WEBSITE: SteamUp YOUTUBE: SteamUp

  • Full Member
  • ***
  • Posts: 563
  • Location: Minnesota
Re: Doll Flywheel Set Screw Questions
« Reply #3 on: March 16, 2024, 02:47:21 pm »
Sometimes those engines have an oddball fine thread of Metric.
On what I believe to be a Märklin saw bench, the grub screw broke but luckily was able to get it apart. I ordered a assorted pack of Metric set screws and one of the Metric screws fit perfectly.  It's a hex socket but it works.
Logged
Pages: [1]
« previous next »