Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

Hi guys,
I'm checking back in. I had a few other projects going on to finish up before I could shift my focus back on my steam project.

I have ordered some steam oil from PM research and one of their oiling kits.

My next question is - what do I need to connect the 504 boiler to the 10V? I see Stuart sells a steam and exhaust pipe set:

https://www.stuartmodels.com/products/fittings--tools---accessories/lubricators-and-pipework/steam---exhaust-pipe-sets

Is that what I'd need to start off? I'd also need to get a small pipe bender, but I do see some around for sale online.

I have also seen some people having a small hand pump and water tank to feed the boiler water. Do I need to get one? If not, how much run time do I get on the boiler (how would you re-fill the water without a hand pump / water tank?

Lastly - As a complete newcomer who has never fired a steam boiler, is there a good source of information about firing a boiler up for the first time - the do's and don'ts of operating a boiler.. as well as the do's and don't of operating a model steam engine?

Ok, well not quite lastly - is there a good source of pulley / belts out there? (I have no access to a lathe to machine anything)

Thanks everyone!