Office of Steam Logo_1

« previous next »
Pages: 1 [2]

Author Topic: Flame Licker Thread  (Read 1267 times)

  • Sr. Member
  • ****
  • Posts: 1077
  • Location: Gahanna, Ohio
Re: Flame Licker Thread
« Reply #15 on: July 01, 2019, 02:27:50 pm »
That's certainly a great and varied collection Doug - never realized there were so many different ones out there. The only one I have is a PMR #3 which I love when it runs correctly but is a pain when it doesn't want to cooperate - a little tricky at times and I fully understand building one and then not being able to get it to run.
Logged
Regards,
Larry

frazer heslop

  • Guest
Re: Flame Licker Thread
« Reply #16 on: July 01, 2019, 04:54:27 pm »
An old video of my P Duclos flame gulper
Iv built loads of these wee engines and currently going through them to clean them and get rid of some wear n tear
This one is nearly 30 years old and has ran for many hours at shows over the years. It was my first build and still my favourite engine
The video was done to help another builder out so forgive its rough edges It is also on the clean up list
cheers
Logged
Pages: 1 [2]
« previous next »