Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

Will do Nick. While I am here I wanted to point out the extra (stuff) I am doing is not needed to get this kit assembled and running. One of the first instructions in manual is sand all the places (where gaskets go) with some fine sandpaper (included) placed on glass or Granite surface plate...or just the flatest thing you have. This removes machine marks and small imperfections and greatly improves your chances of engine being steam tight in first go.
  Then you are advised to wash sanded parts with dish soap and water being careful to try to remove 100% of grit residue...I would say after this step is complete you would need less than 2.5 hours to assemble...this is allowing tons of time to look back to manual and work with care. After you are familiar with model you could likely tear it completely down and re assemble in under an hour.
  Many parts ARE small, I have been working over a plate but a light color towel would also work well. In my old house the wood plank flooring has gaps many over 3/16 wide so most parts smaller than 1 to 2mm that hit the floor are just...gone forever!
  The tinkering and wrenching and personal mods are my favorite part so I am making it last!
But I did not want potential kit buyers to think this was a several day project.