Office of Steam Logo_1

« previous next »
Pages: [1]

Author Topic: Need the pitch of a Wilesco steering shaft  (Read 505 times)

  • Newbie
  • *
  • Posts: 2
Need the pitch of a Wilesco steering shaft
« on: January 22, 2024, 11:49:25 am »
Hello everyone.I am working on installing Wilesco traction engine steering on a Mamod TE1A.  I have it all together but encountered a problem.
  The steering shaft is too long and needs to be shortened and the threads extended.  Seems simple enough, but I can not determine the threat pitch of the Wilesco steering shaft.
  I have M3, M3/0.35,M3/0.5 M3/0.6 but nothing seems to thread onto the Wilesco steering shaft.

  Can someone tell me the pitch of a Wilesco traction engine steering shaft?  I would really appreciate it.
Logged

  • Sr. Member
  • ****
  • Posts: 1817
  • Location: The Winter Wonderland, Michigan.
Re: Need the pitch of a Wilesco steering shaft
« Reply #1 on: January 24, 2024, 02:23:08 pm »
Are you looking to cut the steering shaft off on the end where the steering wheel goes?
Then run a die down to recut threads on it? I'll dig around on mine and see what taps
and die I have.
If you're modifying it why stick with metric threads. See what you have in SAE and
a nut too.
Logged
Tommy

"Steam it, like you mean it."

  • Newbie
  • *
  • Posts: 2
Re: Need the pitch of a Wilesco steering shaft
« Reply #2 on: March 01, 2024, 08:53:30 pm »
  I worked it out, it's M3-0.50.  Yes, I extend the threads about a inch and then cut off the steering shaft half a inch.  I have done this on a couple of the Mamods and it works pretty good.
  Thanks everyone for replying.
Logged

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4122
  • Location: Plano, Texas
Re: Need the pitch of a Wilesco steering shaft
« Reply #3 on: March 02, 2024, 04:33:34 pm »
Problem Solved!

Great to hear.

It would be great if you posted a picture of your modification.
Logged
Pages: [1]
« previous next »