Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

Quote from: Scorpion2nz on February 10, 2025, 05:44:34 pm

Quote from: Jim on February 10, 2025, 04:43:40 pm

Dennis see where it started to melt where I soldered the steam lines in?
That was the smallest flame possible, gotta' be quick!
Moved a bit further with it this morning, looking good.

I drill and thread 1/8th by 40 tpi .
 Thread pipe . Screw in and “electric solder iron “

I'll try that on the next two.
I drilled oiling holes for the shaft.
Where these ever a commercial Cranko line Dennis?
What's the backstory?

The brown one is Cranko
The one to the left is earlier Cranko,
 The red and green on right is AME  from ex Cranko stock

[ Guests cannot view attachments ]