Fitting of the burner, attached to the platform by a threaded ring the two holes in the ring is so i can tighten it with a lens spanner
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
The other thing to watch out for is the spacing of the wick below the boiler dispite my mistake in sizing it looks not too bad the only other thing i have to do is to make an adaptor for the boiler outlet pipe i want it to run down vertical at 90degrees and that should really take care of all things below the waterline.
Bit slow this month due birthdays,family visits, shopping and so on but still progress