Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

Good Morning..

  I was watching this engine but found others
that fit my collection better.  Given that,
these small engines are cute.

  I agree, leave as much as possible 'as-is' after
a gentle cleaning.  I always use a very light oil,
Diala, for an initial wipe-down, then decide if
there are any glaring appearance problems.  All
others are badges of history.  You can then decide
if there is are restorations or repairs to be done.
I would do so before any painting.  Don't forget
lots of before and after pix!

  Now, it does look like the sliding valve link has
a broken end.  You'll have to address that before
it will run.  You will also need a new boiler strap
and I don't know what purpose that thing hanging
off the boiler end serves, unless there is a big
hole there and that would be bad news..     

  So, take a deep breath, make a plan, and get to it.
You'll love it, then take a video of it running, and
show it here.

Good Luck,
Wayne