Office of Steam Logo_1

« previous next »
Pages: 1 [2]

Author Topic: New Line shaft workshop  (Read 5621 times)

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2529
  • Location: Jutland
    • www.SteamUp.dk
Re: New Line shaft workshop
« Reply #15 on: May 14, 2020, 04:42:47 am »
Was in need of a tiny "pulley-puller" a couple of years ago, and decided to try out one of these cheap Chinese models:

https://www.ebay.com/itm/Motor-Pinion-Gear-Puller-Remover-Tools-Set-For-Rc-Helicopter-Motor-Pinion-P-V2T2/283877675226

Much to my surprise, it actually works very well, and is much better quality than iŽd initially expected.
Furthermore, special inserts for the "horseshoe" is very easily made, if one doesnŽt want to alter the original on such an expensive tool ;)
Only downside iŽve found, is that the width of the "horseshoe" does restrict the size of wheel that can be pulled, but on the other hand the tool itself doesnŽt demand much room in tight spaces.
Logged
Cheers
Jan
WEBSITE: SteamUp YOUTUBE: SteamUp
Pages: 1 [2]
« previous next »