Office of Steam Logo_1

« previous next »
Pages: [1]

Author Topic: P 60 Governor  (Read 1444 times)

  • Jr. Member
  • **
  • Posts: 21
  • Location: NewYork State
P 60 Governor
« on: March 11, 2019, 05:17:22 pm »
I have a p 60 governor from Microcosm that I need to get the spring off to put a softer one on . Has any one done this ? I tried but could not get it apart. Any help would be great. Thanks.
Logged
Brian

  • Jr. Member
  • **
  • Posts: 183
  • Location: Pretzel City PA
Re: P 60 Governor
« Reply #1 on: March 11, 2019, 05:34:34 pm »
I wonder if there is loctite holdingbit somewhere?
Logged
I think I have OCD??

  • Global Moderator
  • Engineer
  • *****
  • Posts: 5593
  • Location: St. Paul Indiana
Re: P 60 Governor
« Reply #2 on: March 13, 2019, 05:52:09 am »
Quote from: steam 4301 on March 11, 2019, 05:17:22 pm
I have a p 60 governor from Microcosm that I need to get the spring off to put a softer one on . Has any one done this ? I tried but could not get it apart. Any help would be great. Thanks.
remove the nut from the top & then 3 retaining clips from either the top or bottom set of flyball arms.
Logged
Bruce, St. Paul Indiana, USA
"Originality thrives in seclusion free of outside influences beating upon us to cripple the creative mind."
  Nikola Tesla

  • Jr. Member
  • **
  • Posts: 21
  • Location: NewYork State
Re: P 60 Governor
« Reply #3 on: March 13, 2019, 03:59:17 pm »
I tried that. There is a collar on the rod under the nut that I cant get off. Any ideas ?
Thanks Brian
Logged
Brian
Pages: [1]
« previous next »