Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

I have some various gasket sheets - fiber/rubber, old school paper and punches.  I use that stuff for the Weeden bayonet fittings, I just can't get the bottom sealed (with the stuff I have).  The bottom hole was in pretty bad shape and I think I am going to get it as clean as I can.

Here is a photo of the front of the tank, with the old seal and one of the ones I made tonight.  Its not quite fiber or rubber, its like both in one.  Works wonders on Weedens bayonet fittings.  I don't have a punch small enough for the center tube hole, so I had to use a small drill bit.  I think I need more rubbery or as you say, try and find some small o-rings.  Though I will get some PTV as backup  

As always, thank you for you tips & advise - it is well received! 

[ Guests cannot view attachments ]