Office of Steam Forum for Model & Toy Steam Gas & Hot Air Engines

Hi,

With the Henley’s fore deck made, there was the first attempt at fitting out the hull with the other parts of the model. The only major part needing further work is a means of securing the boiler into the hull. This done the model will be left until the warmer weather arrives in a few months so that it can be rubbed down and painted. With this achieved the hull can be fitted out again and hopefully a test in some water will take place. So, to the great relief of all, the next post on fitting the boiler will be the last one about the Henley for some time.
A video of checking out the engine propeller shaft connection can be seen at:

https://youtu.be/wcxTordBraY?si=mepPgwsI_nzw9VTM

Take care Tony.
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]