Office of Steam Logo_1

« previous next »
Pages: [1]

Author Topic: Making a Flywheel for a Model Traction Engine.  (Read 720 times)

  • Full Member
  • ***
  • Posts: 634
  • Tony Bird
  • Location: Cardiff, South Wales, UK
Making a Flywheel for a Model Traction Engine.
« on: October 07, 2022, 03:30:48 am »
Hi,

Almost a working day was spent making a replacement fly wheel for a Mercer traction engine. starting with a square block of steel.
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]

Take care Tony.
Logged

  • Full Member
  • ***
  • Posts: 546
  • Location: Land of Lincoln Illinois
Re: Making a Flywheel for a Model Traction Engine.
« Reply #1 on: October 07, 2022, 09:49:18 am »
Imagine that flywheel hiding inside that block of steel... Nice work!
Logged
Give us this day our daily Steam
And deliver us from Diesels
          Bret

  • Global Moderator
  • Engineer
  • *****
  • Posts: 5596
  • Location: St. Paul Indiana
Re: Making a Flywheel for a Model Traction Engine.
« Reply #2 on: October 08, 2022, 06:11:14 am »
there's a whole lot of transformation that went on behind the scene, well done Tony.
Logged
Bruce, St. Paul Indiana, USA
"Originality thrives in seclusion free of outside influences beating upon us to cripple the creative mind."
  Nikola Tesla
Pages: [1]
« previous next »