Keep the brass sheet handy Dennis, you'll need another base for the special model Pericaud pump.
[ Guests cannot view attachments ]
That is the second rectangle trough we know of .
could be a bit more difficult to make
More work on the bases
3 bottom plates and 3 top plates .
[ Guests cannot view attachments ]
Soldered together and some tidying up
[ Guests cannot view attachments ]
Very nice. Coming along Brilliantly, you are very talented.
You can literally see the hours you've put into these Dennis.
Turned 3 cups that screw into base for the upright column to fit into .
As per usual no photos .
Turned and fitted 1 upright column
Starting to see some progress now
Cheers
Dennis
[ Guests cannot view attachments ]
I hadn't realised you were building them in a smaller scale and they look very nice at this size.
Have you thought of adding an oil cup or oiling hole to the bearing?
I hadn't realised you were building them in a smaller scale and they look very nice at this size.
Have you thought of adding an oil cup or oiling hole to the bearing?
Did you miss the clue in my first post “ 66% “ and the second photo in first post
Had no thought about an oiler yet
Cheers
Dennis
These are looking great Dennis!!
The valved pistons are made .
need 3 but made 4 as some technical issues arose with the first one
[ Guests cannot view attachments ]
How long is the production run going to be? I want in.
The valved pistons are made .
need 3 but made 4 as some technical issues arose with the first one
Who’s to blame, you or the elves?
The valved pistons are made .
need 3 but made 4 as some technical issues arose with the first one
Who’s to blame, you or the elves?
Most likely the local Troll