Hi,
Along with the Hornby tinplate wagons I bought(see another thread) came eight part machined cast iron wheel castings. At least they were drilled and machined on their backs and might have been used in this state though there is no evidence of this.
The wheels as received.
[ Guests cannot view attachments ]
First they were painted.
[ Guests cannot view attachments ]
Then their backs were cleaned using wet and dry paper.
[ Guests cannot view attachments ]
The axle holes were drilled through.
[ Guests cannot view attachments ]
They were then mounted in a lathe chuck and their fronts machined.
[ Guests cannot view attachments ]
A spigot with a drive pin was made to allow the tread and flange to me machined.
[ Guests cannot view attachments ]
A spigot with a driving pin was made to allow the tread and flange to be machined.
[ Guests cannot view attachments ]
The finished wheels.
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
I have no immediate use for these wheels but I expect they will come in useful in the near future.
Regards Tony.
Hi ,
Sorry I have made a complete mess of this post. I must admit not being able to see the pictures just their codes when editing isn't the easiest system I have used. Still I hope the general idea comes across.
Regards Tony.
No problems understanding your operations and following the post what so ever!
Those wheels cleaned up nicely, so I suspect you are likely to find use for them sooner than you think.
Tony, the wheels look great.!
Enjoyed looking at how you did the wheels Tony.
How do you find the tangential tool? Recommend one?
What a difference, they don't like the same parts.
Hi Jim,
How do you find the tangential tool? Recommend one?
About 25 years ago I think they were called Burke Engineering who designed and made this tool sent a video of it working to model engineering clubs in the UK. Working in the horological trade I was very used to tangential tools but didn't know they were called that; I knew them as a graver that we used for turning by hand. I thought it was a brilliant application of an old tool. It has been my tool of choice ever since for general turning.
Take care.
Tony.
Hi Jim,
How do you find the tangential tool? Recommend one?
About 25 years ago I think they were called Burke Engineering who designed and made this tool sent a video of it working to model engineering clubs in the UK. Working in the horological trade I was very used to tangential tools but didn't know they were called that; I knew them as a graver that we used for turning by hand. I thought it was a brilliant application of an old tool. It has been my tool of choice ever since for general turning.
Take care.
Tony.
Appreciated Tony, I have pondered buying one for ages.
Jim, perhaps the very best thing about these tools is the rather universal aspect of them, being able to take cuts in both X & Y axis with equal ease using the same tool at the same setting. The other wonderful thing about these tools is that there is only one surface of your cutter that needs to be dressed, as all the relief angles are taken care of by the rake angle of the bit as held. Yes, there will still be need for using conventional cutting bits for specialty operations, but at least 90% of normal stock removal can be done with this set-up, and generally without even changing anything at the tool post.
I'm rather new to this myself, but find that I'm using it more and more all the time, and it saves a lot of time so doing!
Hi Jim,
You can use round as well as square bits, they used used to make one for small lathes but I think discontinued, and there is a right hand version as well.
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
Take care.
Tony.
What a difference! 
